PSFacies Stacking Patterns in a Late Jurassic Bahama-Type Platform Interior, Dinaric Platform, Croatia*
By
Antun Husinec1 and J. Fred Read2
Search and Discovery Article #50013 (2005)
Posted August 14, 2005
*Modification by the authors of their poster presentation at AAPG Annual Convention, Calgary, Alberta, June 19-23, 2005.
 
Click to view article in PDF format.
1Institute of Geology, Zagreb, Croatia (presently Virginia Tech)
2Virginia Tech, Dept. of Geosciences, Blacksburg, VA ([email protected])
Abstract
The immense, several kilometers thick Bahama-type carbonate platform of the Dinarides was initiated in the Permo-Triassic as a portion of a land-attached Tethyan platform (Fig. 1). It developed into a Jurassic-Cretaceous isolated platform following breakup of the Adria microcontinent. Well exposed Mesozoic sections along the Dalmatian coast (S. Croatia) reveal the detailed stacking patterns of facies within the Late Jurassic (Tithonian) shallow platform interior (over 700 m thick). Subsidence rates (Fig. 2) during the Tithonian were relatively rapid (12-15 cm/k.y.) slowing to 6 cm/k.y. in the Early Cretaceous (Berriasian-Valanginian), and decreasing even further (1-3 cm/k.y.) from the Hauterivian to Aptian.
Facies of 
parasequences
, 2 to 3 m thick (Fig. 3), include deeper lagoon dasyclad 
wackestone, oncoid wackestone, shoal-water skeletal or ooid packstone and 
grainstone, restricted lagoon lime mudstone, tidal flat microbial laminites and 
fenestral carbonates; transgressive, periodically emergent radial-ooid 
grainstone is common locally. Sections consist of 8-15 meter thick parasequence 
sets roughly 100 k.y. duration based on long-term accumulation rates (Fig. 4). 
Lower Tithonian sets are dominated by thick subtidal 
parasequences
 passing up 
into thin, more shallow water 
parasequences
. Upper Tithonian sets also have 
thick subtidal 
parasequences
 in lower parts passing up into thin muddy peritidal 
parasequences
 with oolitic bases and microbial laminite caps. Estimation of 
water depths using the fenestral/microbial carbonate as a sea-level datum, show 
that the subtidal facies had overlapping depth ranges, implying mosaic-like 
facies patterns.
Accommodation 
(Fischer) plots of the cyclic successions show four accommodation events 
approximately 1 to 2 m.y. duration equivalent to 3rd order 
sequences
. 
These Tithonian 3rd order 
sequences
 evident on the Fischer plots may be partly 
equivalent to the four major sea-level cycles depicted on the Haq and Al-Qahtani 
(2005) chart, but it is not clear how they relate to Hardenbol et al. (1998) 
chart. Roughly 3-5 
parasequences
 make up the 100 k.y. parasequence sets 
suggesting variably recorded eccentricity and precessional forcing. The presumed 
100 k.y. bundles show up as smaller-scale rises and falls on the accommodation 
plots. The relatively high Tithonian subsidence rates likely favored relatively 
complete preservation of precessional cycles with few missing beats, in contrast 
to the more slowly subsiding parts of the Early Cretaceous where more missing 
beats are likely.
Radial ooid 
grainstones ranging from sand to granule size occur mainly at bases of 
parasequences
 and less commonly in upper parts of 
parasequences
 beneath barren 
mudstones or microbial laminites. Poor sorting and the irregular outlines 
suggest that these formed in ooid-precipitating settings that were not 
constantly high-energy as on shallow platform margin shoals. Instead they formed 
in low energy, periodically agitated shallow subtidal lagoon and intertidal 
hypersaline pond settings within the platform interior. Common broken and 
recoated oids (vadoids) probably indicate periodic drying and wetting that 
cracked and broke the grains, followed by renewed precipitation of radial ooid 
coats. The transgressive oolitic units overlying tidal flat facies likely formed 
in hypersaline ponds as the tidal flats were being submerged by relative 
sea-level rise. Some of the thicker oolites (2-3.5 m) if not composite units, 
could have formed during transgression with the sediment surface overtaking 
sea-level rise in the lagoon. The radial calcite fabrics are compatible with 
Late Jurassic calcite seas in contrast to reported Middle Jurassic former 
aragonite ooids, but their fabrics also point to low energy. 
The lack of subaerial surfaces in the Tithonian likely is due to the high accommodation rates which even during falling sea-level prevented prolonged emergence of the platform. As a result, 3rd order low sea-level stands were preserved as stacked cycles in the lagoon. However, there are numerous emergence surfaces above the Jurassic/Cretaceous boundary. These occur as extensive sequence-bounding subaerial clayey limestone breccia horizons interstratified with cyclic carbonates. These emergence horizons may reflect the almost 50% reduction in subsidence rates from the Tithonian to Berriasian.
The presence of 100 k.y. bundles in the Late Jurassic has also been observed in the Early Cretaceous elsewhere by others, and ascribed to presence of some polar ice. The abundant laminite capped, precessional cycles suggest greenhouse, low amplitude sea-level fluctuations, that generated water depths typically less than 5 m on the platform. This seems compatible with the Tithonian being the very warm phase in the overall Late Jurassic-Early Cretaceous cool mode of Frakes et al. (1992). The Jurassic-Cretaceous sections of the Dinaric platform in Croatia may provide important paleoclimatic data for this time interval during which some of the world’s major petroleum reservoirs were generated.
Fig. 3. Succession of facies within a typical Upper Tithonian parasequence, Dinaric platform.
Fig. 4. Selected portions of measured sections 
showing (left-hand column) 
parasequences
 with thick subtidal units and 
(right-hand column) oolite-proned 
parasequences
. The small horizontal lines show 
5th order possible precessional cycles and the heavy lines to the 
right mark parasequence bundles that are possible short-term eccentricity 
cycles.